How To Make MTK DroidTools Backup Of All MTK Android Phones

Hello everyone, today i’ll be showing us how to make an MTK Droid Tools Backup of our MTK device (e.g, Tecno, Infinix,Gionee, Innjoo, TLC, Lead1, Opsson. etc.). So ensure you follow the below procedures step by step.



  1. If you get an error saying “Error: file adbd not install”. Install and run busybox on your device and, click install and allow it to do its thing or Enter here to fix it then come back to this post.
  2. If you get an error saying “insufficient space on device” then ensure there’s at least 4GB free space on both phone storage and SD card
  3. If you get an error like “Preparation of files for FlashTool is impossible, file isn’t found” then remove all scatter files in the backup folder except one and rename this last one to MT65??_Android_scatter ( where “??” represents the number for your phone model e.g MT6572_Android_scatter)


  1. Enable USB debugging on the good MTK phone (Settings > Developer > Tick USB Debugging) then connect it to PC. If you don’t find Developer under Settings then go to Settings > About > Keep taping Build Number
  2. Install PdaNet on the PC with the USB debugging enabled working MTK phone still connected (Select Other from the list of devices during installation)
  3. At the end of PdaNet installation, you should get a “drivers successfully installed” message
  4. Exit PdaNet in system tray (bottom right corner of PC)
  5. Launch MTK droid tools as Administrator (right-click > run as Administrator) still with the working MTK phone connected to PC
  6. MTK droid tools should detect and display the phones details by the left along with a yellow box at the bottom
  7. Click ROOT at the bottom of MTK and select Yes/OK if prompted on PC and Grant if prompted on phone.
  8. A progress bar should load at the bottom shortly after which the yellow box should become green. If it dosn’t turn green, download & install “busy box.apk”. Launch busy box and install “shell” then plug your phone back to PC & repeat step 7.
  9. Click on the root,backup,recovery tab at the top
  10. Click Backup (MTK should keep writing some things by the right hand side during backup) and wait till backup is complete
  11. If you get a prompt to pack backup, select No.
  12. Once backup is complete, don’t close MTK droid tools
  13. Go to the MTK droid tools folder > Backups > Folder named after the phone’s model e.g Tecno_m3_backup…. and take note of this folder as the ‘Backup folder’ because we’ll be referring to it soon
  14. Go back to MTK droid tools and click ‘To prepare blocks for Flash Tool’
  15. A window will open, in this window, navigate to the Backup folder (mentioned above) and select the md5 file
  16. MTK will start copying some items (check the right hand side) so wait till copying is complete
  17. Once copying is complete, open the Backup folder and you should see a folder named “!Files to flash” 
  18. The !files to flash folder is a selection of files needed to use Sp flash tools, keep it well
  19. Both the !files to flash folder and the x_backup folder (which contains the !files to flash folder) are your phone’s MTK backup